Luminex xPONENT 4.2 for FLEXMAP Manual de usuario descargar pdf (Pagina 53)

• Number of Standards - Click to type the number of standards for the protocol.

• Number of Controls - Click to type the number of controls for the protocol.

• Fit of all Standards - The standard curve is determined by using each individual

standard replicate when calculating the standard curve. For example, if you run

duplicates of a 7-point standard curve, the software will calculate the standard curve

by using 14-points.

• Mean of Replicates - The standard curve will be determined by averaging the

individual standard replicates when calculating the standard curve. For example, if

you run duplicates of a 7-point standard curve, the software will calculate the standard

curve by using 7-averaged points.

• Analyze Results While Acquiring Samples - The software allows for real-time

viewing of the results as the instrument analyzes samples.

• Use External Analysis Program - Select this check box to use a third-party program

to analyze the data. The Analysis Program list becomes active when this is selected.

• Analysis Program - Use this list to select which program to use for data analysis.

• Cancel - Click to return to the main Batches tab.

• Next - Click to advance to the Analytes tab.

Analytes Tab

Batches > Batches > Analytes

Use this tab to select or edit analytes used in the batch or protocol.

This tab contains the following:

Batches Page

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 147 148

Sin comentarios

Luminex xPONENT 4.2 for FLEXMAP Manual de usuario Pagina 53