Luminex FLEXMAP 3D User Manual Manual de usuario descargar pdf (Pagina 48)

6. Plug in the power cord and turn on the FLEXMAP 3D

instrument.

Use the software to run the prime command twice.

FIGURE 20.

Front of Fluidics Bay (Inside Left Door)

1 Top quick-disconnect point

2 Sheath Filter

3 Bottom quick-disconnect point

Storing the Luminex

FLEXMAP 3D

Instrument

If you need to put the Luminex

FLEXMAP 3D

instrument in long-term storage or prepare it

for use after removing it from long-term storage, use the following procedures.

Storing the Luminex

FLEXMAP 3D

Instrument

This procedure explains the steps you should take before placing the Luminex

FLEXMAP

instrument into long-term storage.

To prepare the FLEXMAP 3D

instrument for storage:

1. Use the software to perform a Preparation for storage routine.

Luminex

FLEXMAP 3D

Hardware User Manual

For research use only. Not for use

in diagnostic procedures.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 85 86

Sin comentarios

Luminex FLEXMAP 3D User Manual Manual de usuario Pagina 48